Xerox_WorkCentre_635_Communication_Error

ERROR CODE	DESCRIPTION	SOLUTION
10	Add paper, repeat operation.	RX
11	Clear paper jam, perform RAP 30.	RX
12	Clear document jam, perform RAP 40.	TX
13	The top cover was opened and the transmission aborted. Repeat the operation.	TX
20	A power failure occurred during the operation, and the document data was cleared. Repeat the operation.	TX/RX
22	A file error occurred due to a directory error. Perform a memory clear. If the error reoccurs, replace the Main PWB (REP 6.8)	TX/RX
30	The communication was aborted by pressing the Stop key.	TX/RX
32	The actual number of document pages done not match the designated number of document pages. The documents were transmitted anyway.	TX
33	Due to mismatching of the polling password or absence of the polling document, polling was not performed. Check the polling password, confirm the polling document on the sending machine and repeat the operation.	RX
42	The memory was exceeded in a transmission or reception. Check the memory condition, and repeat the operation. Perform Direct Send Transmission if the document is too large for memory.	TX/RX
50	The remote machine's line was busy. Check the memory condition and repeat the operation.	TX
53	Due to security feature, it was not possible to receive documents from the party whose fax number did not match the number assigned to any Speed or One Touch dialing numbers.	TX
87	Full memory to remote machine. Check remote machine, then repeat operation.	TX
BO	NSF/DIS cannot be detected. (Initial signal not detected). Check the receiving machine, and repeat the operation. Perform RAP 54.	TX
B1	The Station Number did not match. DIS/NSF that cannot be handled by the sending side was received. NSS or DCS other than those declared with the DIS/NSF on the receiving side was received. Check the functions of the sending/ receiving machine, repeat the operation. Perform RAP 54	TX/RX
B2	DCN received (Phase B Error), repeat the operation. Perform RAP 54.	TX/RX
B3	DCS/DTC not detected (Phase B Error), repeat the operation. Perform RAP 54.	TX/RX
B4	Training error. The sending side did fall-back but no transmission was possible. The receiving side had a time out or received DCN after a time out. Perform ADJ 5.2 on the sending machine, then repeat the operation. Perform RAP 54.	TX/RX
B5	CFR not detected (Phase B Error), repeat the operation. RAP 54.	TX/RX
C0	Picture signal carrier not detected, repeat the operation. Perform RAP 54.	TX/RX
C1	The receiving side could not detect a high speed signal. Perform ADJ 5.2 on the sending machine, then repeat the operation. Perform RAP 54.	TX/RX
C2	Picture signal carrier off, repeat the operation. Perform RAP 54.	TX/RX
C3	Decode error. The receiving side cannot detect EOL or decode in MMR. Perform RAP 54.	RX
C4	EOL time over, repeat the operation. Perform RAP 54.	TX/RX