Call the World of Fax Order Hotline at 1-866-FAX-PART (1-866-329-7278) for Helpful Order Assistance!!!
CLICK HERE TO RETURN TO THE WORLD OF FAX MAIN PAGE TO VIEW ALL OF OUR PRODUCTS
COMMON ERROR CODES FOR THE:
FAX 2300ML
CODE | DESCRIPTION |
71 | Laser scanner motor does not lock |
72 | Cannot detect Beam Detect signal |
73 | No toner box |
74 | Toner empty |
75 | Unit internal temperature error
-
SOLUTION: REPLACE FUSER UNIT |
76 | Fixing heater disconnect -
SOLUTION: REPLACE FUSER UNIT |
77 | Fixing heater temperature detection
thermistor 2 shorts
-
SOLUTION: REPLACE FUSER UNIT |
78 | Fixing heater temperature detection thermistor 2 disconnected
-
SOLUTION: REPLACE FUSER UNIT |
79 | Unit internal temperature detection thermistor disconnected.
-
SOLUTION: REPLACE FUSER UNIT |
80 | Recording paper size setting error. |
82 | Paper supply error |
83 | Paper jam Paper front sensor fails to return |
84 | Paper jam Paper eject sensor fails to return |
87 | Failure to complete the recording operation sequence. |
88 | Recording paper jam The paper eject sensor failed to come on after the paper front sensor came ON. |
8B | Overheating error Thermistor heat error |
A1 | Open cover assembly opened |
A2 | Document to long to scan |
A3 | Document not detected by the rear |
A4 | 50% or greater faulty white level data |
A5 | Faulty operation of DMAO during scanning |
A6 | Faulty operation of DMA1 during scanning |
A7 | One-line feeding time-out error |
A8 | One-line scanning time-out error |
AB | Document feed-in amount measuring error |
AC | Less than 50% white level data error |
B1 | CODEC LSI error |
B9 | Light emission intensity error of the LED array |
BA | Scanning error: The left-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected |
BB | Scanning error: The right-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected |
BC | Scanning error: Reduction miss |
BD | Scanning error: Enlargement miss |
D1 | The MODEM setup bit sticks to High |
D2 | CTS stays OFF or ON if the MODEM RTS is turned ON or OFF, respectively |
D3 | Bit B1 A of the MODEM stays OFF |
D4 | Bit RX of the MODEM stays OFF |