
Call the World of Fax Order Hotline at 1-866-FAX-PART for Helpful Order Assistance!!!
RETURN TO WORLD OF FAX MAIN PAGE
COMMON ERROR CODES FOR THE:
    
FAX 2400ML
| CODE | DESCRIPTION | 
| 71 | Laser scanner motor does not lock | 
| 72 | Cannot detect Beam Detect signal | 
| 73 | No toner box | 
| 74 | Toner empty | 
| 75 | Unit internal temperature error 
      -  
       SOLUTION: REPLACE FUSER UNIT  | 
  
| 76 | Fixing heater disconnect  -  
       SOLUTION: REPLACE FUSER UNIT  | 
  
| 77 | Fixing heater temperature detection thermistor 2 shorts 
      -  
       SOLUTION: REPLACE FUSER UNIT  | 
  
| 78 | Fixing heater temperature detection thermistor 2 disconnected 
      -  
       SOLUTION: REPLACE FUSER UNIT  | 
  
| 79 | Unit internal temperature detection thermistor disconnected. 
      -  
       SOLUTION: REPLACE FUSER UNIT  | 
  
| 80 | Recording paper size setting error. | 
| 82 | Paper supply error | 
| 83 | Paper jam Paper front sensor fails to return | 
| 84 | Paper jam Paper eject sensor fails to return | 
| 87 | Failure to complete the recording operation sequence. | 
| 88 | Recording paper jam The paper eject sensor failed to come on after the paper front sensor came ON. | 
| 8B | Overheating error Thermistor heat error | 
| A1 | Open cover assembly opened | 
| A2 | Document to long to scan | 
| A3 | Document not detected by the rear | 
| A4 | 50% or greater faulty white level data | 
| A5 | Faulty operation of DMAO during scanning | 
| A6 | Faulty operation of DMA1 during scanning | 
| A7 | One-line feeding time-out error | 
| A8 | One-line scanning time-out error | 
| AB | Document feed-in amount measuring error | 
| AC | Less than 50% white level data error | 
| B1 | CODEC LSI error | 
| B9 | Light emission intensity error of the LED array | 
| BA | Scanning error: The left-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected | 
| BB | Scanning error: The right-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected | 
| BC | Scanning error: Reduction miss | 
| BD | Scanning error: Enlargement miss | 
| D1 | The MODEM setup bit sticks to High | 
| D2 | CTS stays OFF or ON if the MODEM RTS is turned ON or OFF, respectively | 
| D3 | Bit B1 A of the MODEM stays OFF | 
| D4 | Bit RX of the MODEM stays OFF | 
FOR A COMPLETE PARTS LISTING FOR THIS MODEL CLICK HERE
RETURN TO WORLD OF FAX HOME PAGE
