Call the World of Fax Order Hotline at 1-866-FAX-PART for Helpful Order Assistance!!!
RETURN TO WORLD OF FAX MAIN PAGE
COMMON ERROR CODES FOR THE:
FAX 3550
CODE | DESCRIPTION |
71 | Laser scanner motor does not lock |
72 | Cannot detect Beam Detect signal |
73 | No toner cartridge loaded |
74 | Toner empty |
75 | In-house temperature error -
SOLUTION: REPLACE FUSER UNIT |
76 | Fixing heater harness disconnected or broken
-
SOLUTION: REPLACE FUSER UNIT |
77 | Heater thermistor short circuit
-
SOLUTION: REPLACE FUSER UNIT |
78 | Heater thermistor harness disconnected or broken
-
SOLUTION: REPLACE FUSER UNIT |
79 | Toner thermistor disconnected or broken
-
SOLUTION: REPLACE FUSER UNIT |
80 | Paper size setting error |
82 | Paper feeding error |
83 | Paper jam. The registration sensor remains ON |
84 | Paper jam. The paper ejection sensor remains ON |
87 | Fails to complete the recording operation sequence |
88 | Paper jam. Even after the registration sensor has gone OFF, the paper ejection sensor stays OFF |
8B | Overheating error |
A1 | Top cover opened |
A2 | Document too long to scan |
A3 | Document not detected by the document rear sensor |
A4 | 50% or more faulty of white level data |
A5 | Faulty operation of DMAO during scanning |
A6 | Faulty operation of DMA1 during scanning |
A7 | One-line feeding time-out error |
A8 | One-line scanning time-out error |
A9 | Abnormal scanning reference voltage |
AB | Document feed-in amount measuring error |
AC | Less than 50% faulty of white level data |
B1 | CODEC LSI error |
B8 | Amplifier gain error |
B9 | Light emission intensity error of the LED array |
BA | Scanning error: The left-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected |
BB | Scanning error: The right-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected |
BC | Scanning error: Reduction miss |
BD | Scanning error: Enlargement miss |
D1 | The MODEM setup bit sticks to high |
D2 | CTS stays OFF or ON if the MODEM RTS is turned ON or OFF, respectively |
D3 | Bit B1A of the MODEM stays OFF |